Description
Book SynopsisBehzad Razavi, Professor of Electrical Engineering at UCLA, leads the Communication Circuits Laboratory (CCL). Emphasizing the use of mainstream CMOS technologies, CCL's research seeks and exploits new devices, circuits, and architectures to push the performance envelope. Razavi holds a BSEE from Sharif University of Technology and MSEE and PhDEE degrees from Stanford. He was with ATT Bell Laboratories and HP Labs until 1996. An IEEE Distinguished Lecturer and IEEE Fellow, his books include Design of Analog CMOS Integrated Circuits, Design of Integrated Circuits for Optical Communications, and Fundamentals of Microelectronics.
Table of ContentsPreface to the Second Edition xv
Preface to the First Edition xix
Acknowledgments xxi
About the Author xxiii
Chapter 1: Introduction to RF and Wireless Technology 1
1.1 A Wireless World 1
1.2 RF Design Is Challenging 3
1.3 The Big Picture 4
References 5
Chapter 2: Basic Concepts in RF Design 7
2.1 General Considerations 7
2.2 Effects of Nonlinearity 14
2.3 Noise 35
2.4 Sensitivity and Dynamic Range 58
2.5 Passive Impedance Transformation 62
2.6 Scattering Parameters 71
2.7 Analysis of Nonlinear Dynamic Systems 75
2.8 Volterra Series 77
References 86
Problems 86
Chapter 3: Communication Concepts 91
3.1 General Considerations 91
3.2 Analog Modulation 93
3.3 Digital Modulation 99
3.4 Spectral Regrowth 118
3.5 Mobile RF Communications 119
3.6 Multiple Access Techniques 123
3.7 Wireless Standards 130
3.8 Appendix I: Differential Phase Shift Keying 151
References 152
Problems 152
Chapter 4: Transceiver Architectures 155
4.1 General Considerations 155
4.2 Receiver Architectures 160
4.3 Transmitter Architectures 226
4.4 OOK Transceivers 248
References 249
Problems 250
Chapter 5: Low-Noise Amplifiers 255
5.1 General Considerations 255
5.2 Problem of Input Matching 263
5.3 LNA Topologies 266
5.4 Gain Switching 305
5.5 Band Switching 312
5.6 High-IP2 LNAs 313
5.7 Nonlinearity Calculations 325
References 333
Problems 333
Chapter 6: Mixers 337
6.1 General Considerations 337
6.2 Passive Downconversion Mixers 350
6.3 Active Downconversion Mixers 368
6.4 Improved Mixer Topologies 393
6.5 Upconversion Mixers 408
References 424
Problems 425
Chapter 7: Passive Devices 429
7.1 General Considerations 429
7.2 Inductors 431
7.3 Transformers 470
7.4 Transmission Lines 476
7.4.1 T-Line Structures 478
7.5 Varactors 483
7.6 Constant Capacitors 490
References 495
Problems 496
Chapter 8: Oscillators 497
8.1 Performance Parameters 497
8.2 Basic Principles 501
8.3 Cross-Coupled Oscillator 511
8.4 Three-Point Oscillators 517
8.5 Voltage-Controlled Oscillators 518
8.6 LC VCOs with Wide Tuning Range 524
8.7 Phase Noise 536
8.8 Design Procedure 571
8.8.1 Low-Noise VCOs 573
8.9 LO Interface 575
8.10 Mathematical Model of VCOs 577
8.11 Quadrature Oscillators 581
8.12 Appendix I: Simulation of Quadrature Oscillators 592
References 593
Problems 594
Chapter 9: Phase-Locked Loops 597
9.1 Basic Concepts 597
9.2 Type-I PLLs 600
9.3 Type-II PLLs 611
9.4 PFD/CP Nonidealities 627
9.5 Phase Noise in PLLs 638
9.6 Loop Bandwidth 645
9.7 Design Procedure 646
9.8 Appendix I: Phase Margin of Type-II PLLs 647
References 651
Problems 652
Chapter 10: Integer-N Frequency Synthesizers 655
10.1 General Considerations 655
10.2 Basic Integer-N Synthesizer 659
10.3 Settling Behavior 661
10.4 Spur Reduction Techniques 664
10.5 PLL-Based Modulation 667
10.6 Divider Design 673
References 712
Problems 713
Chapter 11: Fractional-N Synthesizers 715
11.1 Basic Concepts 715
11.2 Randomization and Noise Shaping 718
11.3 Quantization Noise Reduction Techniques 738
11.4 Appendix I: Spectrum of Quantization Noise 748
References 749
Problems 749
Chapter 12: Power Amplifiers 751
12.1 General Considerations 751
12.2 Classification of Power Amplifiers 760
12.3 High-Efficiency Power Amplifiers 770
12.4 Cascode Output Stages 776
12.5 Large-Signal Impedance Matching 780
12.6 Basic Linearization Techniques 782
12.7 Polar Modulation 790
12.8 Outphasing 802
12.9 Doherty Power Amplifier 811
12.10 Design Examples 814
References 830
Problems 831
Chapter 13: Transceiver Design Example 833
13.1 System-Level Considerations 833
13.2 Receiver Design 848
13.3 TX Design 861
13.4 Synthesizer Design 869
References 886
Problems 886
Index 889
